Front Castor Fork - Toro Line Painter 1200 Service Manual

Front Castor Fork

7
RIGHT
FRONT
1. Castor wheel
2. Bushing
3. Socket head screw (2 used)
4. Lock washer (2 used)
5. Lock nut
Removal (Fig. 16)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. Raise front of machine to allow front castor fork re-
moval. Support machine to prevent it from shifting dur-
ing repair.
3. Depress castor release lever to disengage caster
detent from castor fork.
4. Remove castor wheel from castor fork (see Wheel
Removal in this section).
Chassis and Controls
14
13
12
9
11
10
9
8
4
3
2
6. Castor fork
7. Cap screw
8. Castor plate
9. Bushing
10. Grease fitting
6
5
1
Figure 16
5. Remove flange head screw (item 13), rebound
washer (item 12) and wave washer (item 11).
6. Lower castor fork from chassis.
7. If necessary, remove two (2) socket head screws
(item 3) and lock washers (item 4) that secure castor
plate to castor fork.
8. If necessary, remove bushing(s) (item 9) from chas-
sis.
Page 6 – 16
11. Chassis
12. Wave washer
13. Rebound washer
14. Flange head screw
Line Painter 1200