Pressure Regulator - Toro Line Painter 1200 Service Manual

Pressure Regulator

RIGHT
FRONT
1. Pressure regulator
2. Flange head screw (2 used)
3. Straight fitting
Removal (Fig. 22)
1. Drain paint tank (see Operator's Manual). Operate
line painter in the flush mode to clean paint tubes.
2. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
3. Remove flush tank (see Flush Tank Removal in this
section).
4. If equipped, remove pressure gauge from machine.
Paint System
5
4. Tee fitting
5. Tank support
6. Elbow fitting
Page 5 – 22
144 to 156 in–lb
(16.3 to 17.6 N–m)
7
6
3
4
Figure 22
5. Label hoses connected to pressure regulator to as-
sist in assembly. Remove hoses from fittings on pres-
sure regulator (Fig. 23) (see Quick Disconnect Fitting in
the General Information section).
6. Remove pressure regulator from machine using Fig-
ure 22 as a guide.
7. If necessary, remove fittings from pressure regulator.
8
1
2
120 to 132 in–lb
(13.6 to 14.9 N–m)
7. Bracket
8. Cap screw
Line Painter 1200