Adjustments; Traction Drive Cable - Toro Line Painter 1200 Service Manual

Adjustments

Traction Drive Cable

1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
2. Make sure that traction lever on handle is released.
3. Adjust location of traction cable jam nuts so that trac-
tion cable spring is stretched .120" to .250" (3.0 to 6.4
mm) from it's relaxed state.
4. Make sure that jam nuts are fully tightened and that
boot is positioned on end of traction cable.
5. Secure high tension lead to spark plug.
Line Painter 1200
4
5
1. Traction drive cable
2. Idler bracket
3. Jam nut
Page 6 – 3
2
3
3
1
Figure 1
4. Cable spring
5. Cable boot
Chassis and Controls