Toro Line Painter 1200 Service Manual page 7

Maintenance and Service
1. Before servicing or making adjustments, position
machine on a level surface and apply parking brake to
prevent machine from moving.
2. Disconnect the spark plug wire from the spark plug
and position the wire away from the spark plug to ensure
that the engine will not start accidentally.
3. Make sure machine is in safe operating condition by
keeping all nuts, bolts and screws tight.
4. Never store the machine or fuel container inside
where there is an open flame, such as near a water heat-
er or furnace.
5. Make sure all paint system line connectors are tight
and all paint system hoses and lines are in good condi-
tion before applying pressure to the paint system.
6. Before disconnecting any paint system component
or performing any work on the paint system, all pressure
in system must be relieved.
7. Do not use lacquers, lacquer thinners, acetones or
other solvents when servicing the paint system of the
Line Painter 1200.
Line Painter 1200
8. Do not overspeed the engine by changing governor
setting. To assure safety and accuracy, check maximum
engine speed with a tachometer.
9. Shut engine off before checking or adding oil to the
engine crankcase.
10.To reduce potential fire hazard, keep engine area
free of excessive grease, grass, leaves and dirt.
11. If major repairs are ever needed or assistance is de-
sired, contact an Authorized Toro Distributor.
12.When changing tires or performing other service,
make sure machine is properly supported. If the ma-
chine is not properly supported, the machine may move
or fall, which may result in personal injury.
13.At the time of manufacture, the machine conformed
to all applicable safety standards. To assure optimum
performance and continued safety certification of the
machine, use genuine Toro replacement parts and ac-
cessories. Replacement parts and accessories made
by other manufacturers may result in non-conformance
with the safety standards, and the warranty may be
voided.
Page 1 – 3 Safety