Flush (Water) Tank - Toro Line Painter 1200 Service Manual

Flush (Water) Tank

RIGHT
FRONT
1. Paint tank
2. Tank support
3. Cap
4. Cap insert
5. Gasket
Removal (Fig. 11)
1. Drain paint tank (see Operator's Manual).
NOTE: The nozzle can be removed from the spray
head to allow the flush tank to be emptied faster.
2. Operate line painter in the flush mode until the flush
tank is empty.
3. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch. Remove high tension lead from the spark plug
and position the lead away from the spark plug.
4. Tip tank support to gain access to flush tank (see
Tank Support in this section).
Paint System
1
2
3
4
5
6
7
8
9
10
6. Stud
7. Flush tank
8. Extension spring
9. Tank support rod
10. Spray pump assembly
Page 5 – 16
13
12
11
Figure 11
2
3
1. Flush tank
2. Extension spring
14
11. Elbow fitting
12. Clamp
13. Bushing
14. Flange head screw (4 used)
Figure 12
3. Tank support rod
Line Painter 1200
1