Toro Line Painter 1200 Service Manual page 77

2. Connect traction drive cable to traction lever on ma-
chine handle:
A. Slide cable end onto traction lever and secure
with hair pin.
B. Secure cable to handle assembly with jam nut.
C. Make sure that cable boot is positioned over end
of cable.
3. Connect traction drive cable to traction idler bracket
under machine (Fig. 12):
A. Connect cable spring to idler bracket.
B. Position cable to chassis bracket.
C. Adjust traction drive cable (see Traction Drive
Cable in the Adjustments section of this chapter).
D. Make sure that cable boot is positioned over end
of cable.
4. Secure high tension lead to spark plug.
Line Painter 1200
2
1. Traction drive cable
2. Cable spring
Page 6 – 13
3
1
Figure 12
3. Idler bracket
Chassis and Controls