Toro Line Painter 1200 Service Manual page 73

2. Connect brake cable to brake lever on handle (Fig.
6):
A. Slide cable end onto brake lever and secure with
hair pin.
B. Secure cable to handle assembly with jam nut.
3. Connect brake cable to brake lever on transaxle (Fig.
7):
A. Connect cable spring to brake lever.
B. Position cable to chassis bracket.
C. Tighten cable jam nuts enough to prevent cable
spring hook from coming off transaxle brake lever.
When properly adjusted, the cable spring should not
be stretched.
D. Make sure that cable boot is positioned over end
of cable.
Line Painter 1200
4. Secure high tension lead to spark plug.
1
3
1. Brake cable spring
2. Brake lever
Page 6 – 9
2
Figure 7
3. Cable jam nut
Chassis and Controls