Draining The Fuel Tank; Replacing The Fuel Filter - Toro TRX-250 Operator's Manual

Draining the Fuel Tank

1. Park the machine on a level surface, engage the
parking brake, and lower the boom.
2. Shut off the engine and remove the key.
3. Turn the fuel-shutoff valve to the closed position
(Figure 45).
4. Squeeze the ends of the hose clamp on the
engine side of the valve together and slide it up
the fuel line away from the valve
5. Pull the fuel line off the valve
6. Open the fuel-shutoff valve and allow the fuel to
drain into a fuel can or drain pan.
Note:
If desired, you can replace the fuel filter
at this time; refer to
(page 34).
7. Install the fuel line onto the fuel-shutoff valve.
Slide the hose clamp close to the valve to secure
the fuel line.
8. Wipe up any spilled fuel.
(Figure 45).
(Figure 45).

Replacing the Fuel Filter

Replacing the Fuel Filter
Service Interval: Every 200 hours
Never install a dirty filter if it is removed from the fuel
line.
Note:
Note how the fuel filter is installed in order to
install the new filter correctly.
Note:
Wipe up any spilled fuel.
1. Park the machine on a level surface, engage the
parking brake, and lower the boom.
2. Shut off the engine and remove the key.
3. Turn the fuel shutoff valve to the closed position
(Figure 45).
4. Replace the fuel filter
Filter for Toro engine shown
5. Turn the fuel shutoff valve to the open position
(Figure 45).
6. Check for fuel leaks and repair if needed.
7. Wipe up any spilled fuel.
34
(Figure 46).
Figure 46
g033082