Table of Contents
Advertisement
1
2
Figure 26
1. Line marker
Operating Tips
• Review the safety instructions and read this manual
carefully before operating the machine.
• Thoroughly inspect the area where you will use the
machine and remove all foreign objects.
• Keep everyone, especially children and pets, away
from the area of operation.
• If the machine starts to vibrate, immediately stop the
engine, disconnect the wire from the spark plug and
examine the machine for damage.
• Do not paint wet grass. Paint only dry grass.
• Keep the engine in good running condition.
• To start painting:
• Fill the paint tank with pre–mixed paint
• Move the paint/flush lever to paint
• Start the engine
• Move the speed control lever to the desired gear
• Slowly engage the traction lever
• Engage the paint control
2. Inner spray shield
19
Fill the Fresh Water Tank
The fresh water is used to flush the system. The capacity
of the tank is 2 gallons.
Figure 27
1. Fresh water tank
Using the Flush System
Using the flush system allows the line painter components
to be cleaned without emptying the paint tank. The flush
system introduces clean water from the water tank. The
paint is not being agitated in the tank when in the flush
mode. Flushing the spray system is recommended
whenever the line painter will not be operated for an
extended period of time, such as transporting to a different
work site. Toro does not recommend leaving paint in the
tank overnight. The paint may thicken and clog the lines.
1. Make sure the speed selector lever is in Neutral and
the parking brake is engaged.
2. Rotate the flush/paint lever to the Flush position.
3. Start the engine, if not already running.
4. Engage the paint control and hold it for 15 to 30
seconds. Initially, paint will flow from the nozzle,
however the output will become more diluted over
time.
Note: To minimize paint mess while flushing the system,
the nozzle boom can be removed and directed back into
the paint tank.
Cleaning the Paint System
To clean the line painter:
1. Make sure the speed selector lever is in Neutral and
the parking brake is engaged.
1
Advertisement
Table of Contents
