KoamTac KDC Series User Manual page 59

KDC User
YOUR
Handshake
KDC provides Handshake mode when Data Format is set to Packet Data.
Handshake Mode will increase the reliability of barcode data transmission.

The default mode for Handshake is disabled.

Data transmission speed is slower when Handshake Mode is enabled.

Terminator
The KDC supports various termination characters when the Data Format mode is set to
barcode only. Select <NONE>, <CR>, <LF>, <CR+LF>, or <TAB> as the termination
character. The default terminator is <CR+LF>. The Up/Down/Left/Right arrow terminator is
also available for HID mode.
Chk Duplicate
This option prevents you from collecting duplicate data.
Enter Key
(KDC350 Only)
This option determines the behavior of the '#' key on the KDC350 keypad.
If this option is enabled, the '#' key acts as a keyboard enter key.

 The '#' key finishes the current data input, and stores/sends input data
according to the menu settings of Wedge/Store.
 The cursor moves to next line after the current data input is complete,
regardless of whether there is an data input or not.
 The screen is scrolled up one line if the '#' key is pressed on the last line of
KDC screen.
 If 'Shift' is enabled, remember that the '#' key will input the '#' character.
 When the KDC sends input data to the host, it attaches a terminator selected in
the menu "Data Process  Terminator". This option may be enabled by
scanning a special barcode, as shown in 13.8(KDC350L) and 14.8(KDC350C)
 If this option is disabled, the '#' key acts as a scan button (when 'Shift' is not
enabled).
KDC
59