Reading Nfc Tags (Kdc350N/400N); Reading Hf Rfid Tags (Kdc450); Inputting Data By Using A Keypad (Kdc350); Synchronizing Data To The Host Device - KoamTac KDC Series User Manual

KDC User
YOUR

Reading NFC Tags (KDC350N/400N)

1
. Enable the NFC Power option in the NFC Config menu.
2
. Touch the NFC tag to the back of the KDC350N/400N case, and make sure the tag and
case are within 5cm of each other.
3.
The KDC will show the NFC tag UID and the user will hear a short beep if it has been
read successfully.
4.
The KDC350N/400N may process "Mifare Ultra Light" and "Mifare Ultra Light C" data
only. Other types of tags should be processed in the host application.

Reading HF RFID Tags (KDC450)

The KDC450 may virtually read any ISO/IEC 14443 A or B compliant smartcards, or ISO/IEC
15693 compliant HF RFID tags.
To read a HF RFID tag, touch the RFID card to the back of the KDC450 case, and make sure
the tag and case are within 5cm of each other. The user will hear a short beep if it has been
read successfully.

Inputting Data by Using a Keypad (KDC350)

The KDC350 Enables users to input barcode data by using its keypad. The user may switch
between Num mode and Abc mode by using the Mode button.
To switch between uppercase and lowercase letters, the user may press the Shift button
while in Abc mode. To save the data input, press the Enter or SCAN button. For data input,
press the Menu button. Refer to
detailed information about the process.

Synchronizing data to the host device

Use the KTSync
Please refer to Chapter 6. Synchronization
KDC
Figure 11 - Location for reading NFC Tag
1.4 Input data by using a keypad (KDC350)
® program to synchronize barcode data from the KDC to the host device.
for details.
for more
38