Update Settings - US Robotics Instant802 APSDK Administrator's Manual

4. Restart the syslog server by typing the following at the command line prompt:
/etc/init.d/sysklogd restart
The syslog process will default to use port 514. USRobotics recommends using this default port.
However, if you choose to reconfigure the log port, make sure that the port number that you assign to
syslog is not being used by another process.
Enabling and Disabling the Log Relay Host on the Status Menu's Events Page
To enable and configure log relaying on the Status menu's
described below.
Field
Log Relay Host Enabled
Relay Host
Relay Port

Update Settings

To apply your changes, click Update.
If you enabled the log relay host, clicking
kernel messages real-time for display to the remote log server monitor, a specified kernel log file, or other
storage, depending on how you configured the log relay host.
If you disabled the log relay host, clicking
Description
Choose to either enable or disable use of the Log Relay Host:
• Enabled
• Disabled
If you select Enabled, the Relay Host
Specify the IP Address or DNS
Specify the port number for the syslog process on the relay host.
The default port is 514.
Update will activate remote logging. The access point will send its
Update will disable remote logging.
Professional Access Point
Events
page, set the log relay options as
and Relay Port fields are editable.
name of the relay host.
Administrator Guide
Events - 81