Saving Configuration Changes - US Robotics Instant802 APSDK Administrator's Manual

Interface
wlan0wds x
vlanxxxx

Saving Configuration Changes

The Professional Access Point maintains three different configurations.
• Factory Default Configuration - This configuration consists of the default settings shipped with the
access point (as specified in
You can always return the access point to the factory defaults by using the
described in "Reset the Access Point to Factory Defaults" on page 247.
• Startup Configuration - The startup configuration contains the settings that the access point will use
the next time it starts up (for example, upon reboot).
To save configuration updates made from the CLI to the startup configuration, you must execute the
save-running or "set config startup
• Running Configuration - The running configuration contains the settings with which the access point
is currently running.
When you view or update configuration settings through the command line interface (CLI) using get,
set, add, and remove
only. If you do not save the configuration (by executing the
command at the CLI), you will lose any changes you submitted via the CLI upon reboot.
The save-running command saves the running configuration as the startup configuration. (The
command is a shortcut command for
Settings updated from the CLI (with get, set, add,
configuration unless you explicitly save them via the
maintaining the startup configuration and trying out values on the running configuration that you can
discard (by not saving).
By contrast, configuration changes made from the Web User Interface are automatically saved to both the
running and startup configurations. If you make changes from the Web User Interface that you do not want
to keep, your only option is to reset to factory defaults. The previous startup configuration will be lost.
Description
A wireless distribution system (WDS) interface where "x" indicates the number of
the WDS link. (For example,
A VLAN interface for VLAN ID
(Internal, Guest, VWN1 or VWN2), use the following command to look at the "
field:
get interface vlanVLANID role
For example:
get interface vlan
"Default Settings for the Professional Access Point" on page
running" command from the CLI after making changes.
commands, you are viewing and changing values on the running configuration
"set config startup
wlan0wds1 .)
xxxx
. To find out what this VLAN interface is
1234 role
save-running
running", which accomplishes the same thing)
remove commands) will not be saved to the startup
save-running command. This gives you the option of
Class Structure, Commands, and Examples - 191
Professional Access Point
Administrator Guide
role
16).
factory-reset command, as
or "set config startup running"
save-running
"