Table of Contents
Advertisement
USR5453-AP# set log relay-enabled 0
Specify the Relay Host
To specify the Relay Host, provide either the
"set log
parameters to the
If you are using Instant802 Conductor, the Repository Server should receive the syslog messages
from all access points. In this case, use the IP address of the Conductor Repository Server as the
Relay Host.
•
To specify an IP address for the syslog server:
set log relay-host IP_Address_Of_LogRelayHost
Where IP_Address_Of_LogRelayHost is the
For example:
USR5453-AP# set log relay-host 10.10.5.220
•
To specify a Host Name for the syslog server:
set log relay-host Host_Name_Of_LogRelayHost
Where Host_Name_Of_LogRelayHost is the a
For example:
USR5453-AP# set log relay-host myserver
Specify the Relay Port
To specify the Relay Port for the syslog server:
set log relay-port Number_Of_LogRelayPort
Where Number_Of_LogRelayPort is the port number for the Log Relay Host.
For example:
USR5453-AP# set log relay-port 514
Review Log Settings After Configuring Log Relay Host
To view the current log settings:
USR5453-AP# get log
Field
--------------------------
depth
relay-enabled
relay-host
relay-port
IP Address
relay-host" command as shown below.
Value
15
1
10.10.5.220
514
or a
name for the Log Relay Host as
DNS
IP Address
of the Log Relay Host.
name for the Log Relay Host.
DNS
Class Structure, Commands, and Examples - 204
Professional Access Point
Administrator Guide
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the Instant802 APSDK and is the answer not in the manual?
Questions and answers