US Robotics Instant802 APSDK Administrator's Manual page 249

• Example 1: At a blank command line, hit TAB twice to get a list of all commands.
USR5453-AP#
add
factory-reset
get
reboot
remove
save-running
set
• Example 2: Type "get
command.
USR5453-AP# get
association
basic-rate
bridge-port
bss
cluster
cluster-member
config
detected-ap
dhcp-client
dot11
host
interface
ip-route
klog-entry
log
log-entry
mac-acl
ntp
portal
radio
radius-user
ssh
supported-rate
system
telnet
tx-queue
wme-queue
• Example 3: Type "get system
tem version". (Hit ENTER to get the output results of the command.)
USR5453-AP# get system v
USR5453-AP# get system version
• Example 4: Type "set" TAB TAB (including a space after set) to get a list of all field options for the
command.
USR5453-AP# set
bss
cluster
cluster-member
config
Add an instance to the running configuration
Reset the system to factory defaults
Get field values of the running configuration
Reboot the system
Remove instances in the running configuration
Save the running configuration
Set field values of the running configuration
" TAB TAB (including a space after get) to see a list of all field options for the
Associated station
Basic rate of the radio
Bridge ports of bridge interfaces
Basic Service Set of the radio
Clustering-based configuration settings
Member of a cluster of like-configured access points
Configuration settings
Detected access point
DHCP client settings
IEEE 802.11
Internet host settings
Network interface
IP route entry
Kernel log entry
Log settings
Log entry
MAC address access list item
Network Time Protocol client
Guest captive portal
Radio
RADIUS user
SSH access to the command line interface
Supported rates of the radio
System settings
Telnet access to the command line interface
Transmission queue parameters
Transmission queue parameters for stations
v" TAB. This will result in completion with the only matching field,
Basic Service Set of the radio
Clustering-based configuration settings
Member of a cluster of like-configured access po
Configuration settings
Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 249
get
"get sys-
set