Ready To Get Started; Command Usage And Configuration Examples - US Robotics Instant802 APSDK Administrator's Manual

cluster
cluster-member
config
detected-ap
dhcp-client
dot11
host
interface
ip-route
klog-entry
log
log-entry
mac-acl
ntp
portal
radio
radius-user
ssh
supported-rate
system
telnet
tx-queue
wme-queue
"get system
• Example 3: Type
tem version". Hit ENTER to display the output results of the command.
For detailed examples on getting help, see

Ready to Get Started?

If you know the four basic commands shown above (get, set, remove, and add) and how to get help at the
CLI using tab completion, you are ready to get started.
The best way to get up-to-speed quickly is to bring up the CLI on your access point and follow along with
some or all of the examples in the next topic

Command Usage and Configuration Examples

"Understanding Interfaces as Presented in the CLI" on page 190
"Saving Configuration Changes" on page 191
"Basic Settings" on page 192
"Access Point and Cluster Settings" on page 196
"User Accounts" on page 196
"Status" on page 199
Clustering-based configuration settings
Member of a cluster of like-configured access points
Configuration settings
Detected access point
DHCP client settings
IEEE 802.11
Internet host settings
Network interface
IP route entry
Kernel log entry
Log settings
Log entry
MAC address access list item
Network Time Protocol client
Guest captive portal
Radio
RADIUS user
SSH access to the command line interface
Supported rate of the radio
System settings
Telnet access to the command line interface
Transmission queue parameters
Transmission queue parameters for stations
v" TAB. This will result in completion with the only matching field,
"Tab Completion and Help" on page
"Command Usage and Configuration Examples" on page
Professional Access Point
Administrator Guide
248.
Class Structure, Commands, and Examples - 188
"get sys-
188.