Making A Lan Cable - Mitsubishi Electric MELSEC iQ-F Series Quick Connection Manual

1. PREPARATION
Preparatory Steps
1

1.4.2 Making a LAN cable

Follow the procedure below when making a LAN cable.
Step 1.
Cutting a cable
2
Cut the cable to a required length.
3
Step 2.
Attaching a modular cover
(temporary)
When using a pre-attached type modular cover,
attach it to the cable.
4
Step 3.
5
Stripping a cable jacket
Strip the cable jacket on both ends using a cable
stripper.
It can be substituted with a cutter or a pair of
scissors. When using either one of them, be careful
not to damage core wires.
6
Cut out the cross separator in the cable if applicable.
10
Required Products System Configuration
Pay attention to the
orientation
Connecting a
Wiring
Terminating Resistor
Step 4.
Rearranging core wires
Rearrange the core wires in accordance with the type
of a LAN cable to be made.
Front view of the connector (insertion side)
1) 2) 3) 4) 5) 6) 7)8)
1)
To the next page
1) Orange
and white
2) Orange
3) Green
and white
4) Blue
5) Blue and
white
6) Green
7) Brown
8) and white
8) Brown