Mitsubishi Electric MELSEC iQ-F Series Quick Connection Manual page 6

1. PREPARATION
Preparatory Steps
1
The following items are required for making a LAN cable.
Ethernet cable
2
• Cable type:
3
10BASE-T cable (category 3, 4, or 5)
• Connection specifications:
Straight type
Tools
4
Crimping tool
5
Used to crimp an RJ45 connector.
6
6
Required Products System Configuration
RJ45 connector (modular plug)
• Using a modular plug with a load
bar and clip breakage prevention
is recommended.
Wire stripper
Used to strip cable jackets when
connecting the LAN cables. Wiring
time can be reduced by using this
tool. It can be substituted with a
cutter or a pair of scissors.
Connecting a
Wiring
Terminating Resistor
Modular cover
• Using a pre-attached type
modular cover is recommended.
Optional LAN cable tester
Used to check disconnection of
the self-made LAN cable.
Using a separator type is
recommended.
Optional
Optional