Base Station Id Tag; During Use - MSA G1 SCBA Operating Manual

Niosh cbrn/nfpa 2018 edition

Hide thumbs Also See for G1 SCBA:

Table of Contents

9.4.3 Base Station ID Tag

A base station ID is used to assign a specific base station ID to an SCBA. When more than one base

station is available and actively monitoring at an incident, an SCBA with an assigned base station

searches first for the preferred base station to log onto. If the SCBA does not find the assigned base

station within 20 seconds, it searches for the first available base station and logs onto it. If a base

station ID has not been assigned to the SCBA, the SCBA logs onto the first base station it finds after

being turned on. When a base station ID tag is scanned into the power module, the base station ID

stays with the SCBA until another base station ID tag is scanned.

The user can assign a tag to the SCBA during use.

(1)

Push and hold BOTH green RESET buttons at the same

time until the RFID symbol shows on the control module.

(2)

Put the ID tag over the RFID reader on the power module.

The RFID reader is on the SCBA backplate on the user's

right side.

When the reading is complete, the control module will

show the ID tag information and emit a beep.

(3)

If the control module does not show the ID tag informa-

tion, do Steps (1) and (2) again.

G1 SCBA 2018 Edition

Control Module

Table of Contents