Programming Wr7 Using The Learning Method - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 16
Programming WR7 using the
Learning Method
STEP 1: Line up the WR7 to the remote control you want to
'learn' from, head--to--head as shown below. Start with both
remotes' IR windows touching (or nearly touching).
STEP 2: On the WR7, press the Component button that you
want to program (in this case the button that says TV) and the
ENTER [ENT] button at the same time. Hold down both buttons
for two seconds until the TV Component button light turns on.
This signals that you are in programming mode.
IMPORTANT: You have 30 seconds to perform the next step
while you are in programming mode. If you do not press a
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
STEP 3: Press any button on the WR7 that you want to teach a
command to. For example, if you want to teach the [MUTE] button
on the WR7 the TV Mute command from the other remote, first
press the [MUTE] button on the WR7 and the TV component
button LED light will blink once indicating that the WR7 is ready
to learn the command.
Page 16