Transport Control 'Punch Through - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 28

Transport Control 'Punch Through'

This 'punch through' enables you to program the WR7 so that
VCR or DVD Transport Controls (PLAY, STOP, FF, REW, PAUSE,
SKIP and RECORD) will also operate in other component modes
on the remote control.
STEP 1: Press and hold the component button you want to
add Transport Control to, such as [CABLE/SAT] or [TV], and the
SELECT [SEL] button at the same time for two seconds until the
Component LED light turns on.
IMPORTANT: You have 30 seconds to perform the next
step while you are in programming mode. If you do not press a
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
STEP 2: Press the [PLAY] button. The component LED light will
blink once.
COMPONENT
BUTTONS
SELECT
PLAY
STEP 3: Press either the [DVD] or [VCR] button that you want
to use as the source of Transport Control. The component LED
will blink three times to confirm it is saved.
Page 28