Three-Digit Code Entry Method - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 11

Three-Digit Code Entry Method

STEP 1: Find the 3-digit code numbers assigned to your brand
from the lists in the back of this manual. The codes are listed by
component category (i.e., TV, VCR, DVD, etc.), then by brand
name. For instance, if you would like to locate a code for a
Sony television, first locate the TV category and then look for
the Sony brand.
STEP 2: Once you have located the 3-digit codes for each of
the components that you wish to operate with your WR7, write
them ALL down on a piece of paper. It's important that you write
down all the codes listed for your brand because only one code
is going to work with your component.
STEP 3: Manually or using your old remote, turn on the
component you want to program—for example, to program your
TV turn on your TV set.
STEP 4: On the WR7, press the Component button that you
want to program (in this case the button that says TV) and the
SELECT [SEL] button at the same time. Hold down both buttons
for two seconds until the TV Component LED light turns on.
This signals that you are in programming mode.
COMPONENT
BUTTONS
SELECT
BUTTON
Page 11