Erasing All Learned Commands From One Component - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 31
Erasing All Learned Commands from
One Component
This function allows you to erase all the learned commands from
one component. For example, if you want to erase all learned
commands on the TV component button because you bought a
new TV, the process is very simple.
STEP 1: Press the component button where all the learned com-
mands are stored and the [ENTER] button at the same time for two
seconds until the component LED turns on.
IMPORTANT: You have 30 seconds to perform the next step
while you are in programming mode. If you do not press a
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
STEP 2: Press and hold both the component button you want to
erase and the [PAUSE] button at the same time for two seconds,
until the component LED light blinks twice to confirm the erasure.
COMPONENT
BUTTONS
PAUSE
ENTER
STEP 3: To exit Erase mode, press and hold both the
component button and the [ENTER] button at the same time
until the component LED light blinks three times.
Page 31