Erasing Macropower & Other Macro Commands - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 32
Erasing MacroPower & Other Macro Commands
STEP 1: To erase MacroPower commands on the POWER [ON]
or [SYSTEM OFF] button, press and hold either the POWER [ON]
or [SYSTEM OFF] button and the [MUTE] button simultaneously
for two seconds until the current status component LED turns on.
IMPORTANT: If you don't proceed to the next step within 30
seconds, the LED will turn off and exit set-up mode and you will
need to start over.
STEP 2: Press the CHANNEL UP [CH ] button to erase and
exit Erase mode. The component LED light will blink three times
to confirm the erasure.
SYSTEM
POWER
ON
OFF
CHANNEL
UP
MUTE
NOTE: To erase other Macros, simply press the appropriate
button in Step 1 in combination with the [MUTE] button.
Page 32