Universal CONTROL WR7 Owner's Manual page 22

WR7 1/13/08 12:18 PM
IMPORTANT: You have 30 seconds to perform the next step
while you are in programming mode. If you do not press a button
within 30 seconds, the component LED light will turn off. The remote
will exit the programming mode and you will have to start over.
STEP 2: Press the component button you want to turn on and
then the POWER [ON] button; repeat for all other components
in the order you want them to turn on. The component LED lights
will blink once each time you press the POWER [ON] button.
POWER
COMPONENT
BUTTONS
STEP 3: Once you've entered all the Power On commands,
press the CHANNEL Up [CH
commands. The component LED lights will blink three times to
confirm that the programming has been successfully saved.
SUGGESTION: Most of the components have the same
signal to turn the power On and Off. You may want to program
MacroPower only in the POWER [ON] button and save the
[SYSTEM OFF] button to turn components On or Off individually.
Note: If you want to program MacroPower for the
[SYSTEM OFF] button, repeat the same steps used for
POWER [ON] programming.
Page 22
] button to save your MacroPower
CHANNEL
UP
Page 22