Auto-Search Method - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM

Auto-Search Method

The Auto-Search Method is a way you can scan through
all of the codes in the table to find the right code for
your component.
Manually or using your old remote, turn on the
STEP 1:
component you want to program—for example, to program
your TV, turn on your TV set.
On the WR7, press the Component button
STEP 2:
that you want to program (in this case the button that says
TV) and the SELECT [SEL] button at the same time. Hold
down both buttons for two seconds until the TV Component
button light turns on. This signals that you are in
programming mode.
You have 30 seconds to perform the next
IMPORTANT:
step while you are in programming mode. If you do not
press a button within 30 seconds, the component LED light
will turn off. The remote will exit the programming mode
and you will have to start over.
Page 14
UP
ARROW
DOWN
ARROW
Page 14