Erasing Commands - Overview; Erasing A Single Learned Command - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 30

Erasing Commands - Overview

You can erase a single learned command, all learned
commands in each component mode, SimpleSound programming,
MacroPower commands, or re--set the remote to original factory
default settings.
Erasing a Single Learned Command from
One Component
STEP 1: Press the component button where the learned com-
mand is stored and the [ENTER] button at the same time for two
seconds until the component LED light turns on.
IMPORTANT: You have 30 seconds to perform the next
step while you are in programming mode. If you do not press a
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
COMPONENT
BUTTONS
ENTER
STEP 2: Press and hold the button you want to erase for two
seconds. The component LED light will blink twice to confirm
the erasure.
STEP 3: Repeat Step 2 to erase any other buttons in the selected
component mode.
STEP 4: To exit Erase mode, press and hold both the component
button and the [ENTER] button at the same time until the compo-
nent LED light blinks three times.
Page 30