Osd (On-Screendisplay) Control 'Punch Through - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM Page 29
OSD (On-Screen Display) Control 'Punch Through'
This 'punch through' enables you to program the WR7 so that
CBL or DVD OSD Controls (MENU, GUIDE, INFO, EXIT, SEL and
4 Cursor Controls) will also operate in other component modes
on the remote control.
STEP 1: Press and hold the component button you want to
add OSD Control to, such as [TV] or [VCR], and the SELECT [SEL]
button at the same time for two seconds until the Component LED
light turns on.
IMPORTANT: You have 30 seconds to perform the next step
while you are in programming mode. If you do not press a
button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have
to start over.
STEP 2: Press the [MENU] button. The component LED will
blink once.
COMPONENT
BUTTONS
MENU
SELECT
STEP 3: Press either the [CABLE/SAT] or [DVD] button that
you want to use as the source of OSD Control. The component
LED will blink three times to confirm it is saved.
Page 29