Universal CONTROL WR7 Owner's Manual page 15

WR7 1/13/08 12:18 PM Page 15
STEP 3: Point the WR7 remote control toward the component
and press the UP [ ] arrow (or DOWN [ ] arrow) button
once. Each time the UP or DOWN arrow button is pressed,
the code will count up (or down) one code number and send a
Power OFF signal. When the correct code is sent out, the
component will turn off.
STEP 4: Once you have found the right code number and the
component has turned off, press the POWER [ON] button on the
WR7 remote to turn the component back on.
Next test the VOLUME and CHANNEL buttons (or PLAY and STOP
buttons for VCR and DVD) to make sure they all work. If any of
the buttons do not work properly, you need to find a new code.
Continue pressing the UP (or DOWN) arrow button until you find
a new code that turns off the component and makes the VOLUME
or PLAY buttons respond correctly.
STEP 5: Once you have found the right code, you must
save it. Press the component button you just programmed (in
this case TV) one more time to save the code number. The compo-
nent LED light will blink three times to confirm that the code was
successfully stored. Now when you press the TV component
button, all of the buttons will work with your TV.
NOTE: Use this method for those components you cannot pro-
gram with either the Quick Set-Up or 3-digit Code Entry Methods.
IMPORTANT: If you cannot find the right code after 5 minutes
of trying the Auto-Search Method, try the Learning Method (page 16).
PLEASE DO NOT RETURN
THIS PRODUCT TO THE STORE
PLEASE CONTACT OUR TECHNICAL
SUPPORT CENTER.
IF YOU NEED ASSISTANCE E-MAIL
techsupport@UniversalRemote.com
1-800-901-0800
or dial
(9:00AM - 6:00PM EST)
Page 15