Universal CONTROL WR7 Owner's Manual page 24

WR7 1/13/08 12:18 PM
STEP 3: Using the Number Pad, punch in the Channel
number of the Favorite Channel that you want to store in the
Macro button. The CABLE/SAT component LED light will blink
once for each button pressed.
STEP 4: Press the CHANNEL UP [CH ] button to store the
commands entered. The [CABLE/SAT] component LED will blink
three times to confirm the programming.
Notes regarding programming multi-commands
to Macro buttons:
• You can program up to 20 commands on each Macro button.
• You can program delays in between commands by pressing
the [PAUSE] button. Each press adds a one-half second delay.
• Also, if you add the delay time as the first step of Macro
commands, the remote will not send the Macro unless the
button is held for two seconds. (This is the Press &
Hold Function).
• You can also program macro commands in 'layers' by
pressing the [STOP] button in between commands.
(For example, if you press [009], [STOP], [035], [STOP],
[365], [STOP] in Step 3 of the Favorite Channel programming
process) the remote will send out 009 at the first press of the
selected [My Favorites] button, and then send out 035 at the
second press, etc.
• You cannot program the [CH
macro commands.
Page 24
CHANNEL
UP
] or [PAUSE] buttons as
Page 24