Universal CONTROL WR7 Owner's Manual page 12

WR7 1/13/08 12:18 PM Page 12
IMPORTANT: You have 30 seconds to perform the next step
while you are in programming mode. If you do not press a button
within 30 seconds, the component LED light will turn off. The
remote will exit the programming mode and you will have to
start over.
STEP 5: Point the WR7 toward the component (in this example
the TV) and punch in the first 3-digit code that you wrote down
for that specific component. Use the Number buttons 0~9 on the
remote to punch in the code. The TV LED light will blink each time
a number is pressed.
NUMBER
BUTTONS
If the 3-digit code number you just punched in is the correct
number, the component you are trying to program will turn off.
If it did not turn off, enter the next code number from your list
until it does turn off.
STEP 6: Once you've entered the code number and the
component has turned off, press the POWER [ON] button on the
WR7 remote to turn the component back on.
Next test the VOLUME and CHANNEL buttons (or PLAY and
STOP buttons for VCR and DVD) to make sure they all work.
For example, perhaps your Sony TV turned off with code number
147, but the volume controls did not work properly. In this case,
try the next code number listed for that component. Repeat Step 5
using the next code number until you find a perfect match.
Page 12