Channel Control 'Punch Through - Universal CONTROL WR7 Owner's Manual

WR7 1/13/08 12:18 PM

Channel Control 'Punch Through'

This 'punch through' enables you to program the WR7 so
that either the Cable or TV Channel Controls (CHANNEL UP,
DOWN, LAST, CHANNEL NUMBERS 0-9, +10 and ENTER)
will also operate in other component modes on the remote control.
STEP 1: Press and hold the component button you want to add
channel control to, such as [DVD] or [VCR], and the SELECT [SEL]
button at the same time for two seconds until the Component LED
light turns on.
IMPORTANT: You have 30 seconds to perform the next
step while you are in programming mode. If you do not press
a button within 30 seconds, the component LED light will turn off.
The remote will exit the programming mode and you will have to
start over.
STEP 2: Press the CHANNEL UP {CH } button. The component
LED light will blink once.
SELECT
STEP 3: Press either the [TV] or [CABLE/SAT] button that you
want to use as the source of channel control. The component LED
will blink three times to confirm it is saved.
Page 27
COMPONENT
BUTTONS
CHANNEL
Page 27
UP