Table of Contents
Advertisement
•
Command line interface (CLI) using the RS-232 console cable
The easiest way to configure a static IP address for your network in the
ES7510-XT is to use a Windows host and PortVision DX (see below). For
information about using other configuration methods, refer to the RocketLinx
ES7510-XT User Guide.
Note:
Optionally, you can use NetVision if you are accustomed to using
NetVision. PortVision DX is replacing NetVision. NetVision is not
documented in the RocketLinx ES7510-XT User Guide.
The following procedure uses PortVision DX to program network settings.
1.
Install PortVision DX on a host system with a Windows operating system.
If you need assistance installing PortVision DX, see the RocketLinx
ES7510-XT User Guide.
2.
Start PortVision DX. PortVision DX can be started from Start --> All
Programs --> Comtrol --> PortVision DX.
Click the Scan button.
3.
4.
Select the Comtrol product families that you want to locate and click the
Scan button.
5.
Right-click the ES7510-XT in the Device List pane (lower) that you want
to configure and click Properties.
6.
Enter a user-friendly Device Name, which displays a friendly device
name in the Device List pane on the main page.
7.
Optionally, enter the ES7510-XT serial number.
Select DHCP IP or Static IP for the IP Mode.
8.
•
If you select DHCP IP, go to Step 9.
•
If you select Static IP, enter an IP address, Subnet Mask, and
Default Gateway value for your network.
9.
Optionally, select the appropriate Network Topology, which is an
informational field.
10. Click the Apply Changes button.
11. Click Close to return to the main screen.
You are now ready to configure the ES7510-XT features.
6
Advertisement
Table of Contents
