Table of Contents
Advertisement
2.
Tighten the wire-clamp screws to prevent the wires from coming loose.
3.
Connect an appropriate ground wire between the chassis ground screw
and earth ground to ensure that the ES7510-XT is not damaged by
noise or electrical shock.
a. Loosen the chassis ground screw on the bottom of the unit.
b. Tighten the screw after the ground wire is connected.
Electrical Specifications
Power Input Voltage
PWR1/PWR2
Maximum PoE
Power/Port
Power Budget
Power Consumption
Wiring the Relay Output (DO)
The relay output alarm contacts are on the terminal block connector on the
bottom of the ES7510-XT.
The relay contact supports up to 0.5A at 24VDC. Do not apply voltage and
current higher than the specifications.
The relay output (DO) is controlled by the pre-defined operating rules. To
activate relay output function, refer to
the RocketLinx ES7510-XT User Guide.
Wiring the Digital Input (DI)
The Digital Input (DI)
contacts are on the terminal
block connector on the
bottom of the ES7510-XT.
The contacts accept one
IEEE 802.3af
IEEE 802.3at
IEEE 802.3af
IEEE 802.3at
PWR1/PWR2
Without PD load (max)
PoE with PD load (max)
IEEE 802.3af
IEEE 802.3at
Trigger
Switch
2
Value
46-57VDC/3.4A (Max.)
50-57VDC/3.1A (Max.)
15.4W
30W
120W
15W
160W
3.3A@48VDC
3A@53VDC
Digital Input
24VDC
1 = High Output: 11-30VDC
0 = Low Output: 0-10VDC
Buzzer/
PLC Input
0.5A
+
+
-
-
DI
DO
Power
24VDC
Advertisement
Table of Contents
