Table of Contents
Advertisement
external DC type signal input and can be configured to send alert message
through Ethernet when the signal is changed.
The DI accepts DC type signal and supports isolated input circuit with digital
high level input 11VDC to 30VDC and digital low level input 0VDC to 10VDC.
Do not apply a higher voltage than the specification; it may cause internal
circuit damage or cause an incorrect DI action.
Connecting the Surge/Lightning Protection
Connect a ground wire between the earth ground (surge)
screw and earth ground to provide enhanced surge and
lightning immunity.
1.
Loosen the earth ground screw located on the back
of the unit next to the compliance label.
2.
Tighten the screw after the ground wire is connected.
Make sure that you remove the surge ground screw before
insulation/Hi-pot testing.
Mounting the ES7510-XT
You can mount the ES7510-XT to a DIN rail or use the wall/panel mounting
plate.
1.
Insert the upper end of DIN rail clip into the back of DIN rail track from
its upper side.
2.
Lightly push the bottom of DIN rail clip into the track.
3.
Verify that the DIN rail clip is tightly attached on the track.
Connecting the Ethernet Ports
The ES7510-XT provides RJ45/SFP combo Gigabit ports (Ports 9-10). The
Gigabit Ethernet ports support 10BASE-T, 100BASE-TX and 1000BASE-T.
The SFP ports support 100BASE-FX and Gigabit fiber. When an SFP port is
active and installed on a combo port, the corresponding combo RJ45 port is
deactivated.
Ports 1-8 are Fast Ethernet 10/100BASE-TX PoE ports that are IEEE 802.3af
(PoE) and IEEE 802.3t (PoE Plus) compliant.
3
Advertisement
Table of Contents
