Slide Guide Mounting; Figure 2.6.2 Rack Mount Installation - Fujitsu M2361A Customer Engineering Manual

2.6.2 Slide guide mounting
The slide guide assembly consists of a pair of right and left slide guides.
Mount the slide guide assembly on the 19-inch rack as follows.
(1) Loosen the 2 nuts holding the bracket in the back. so that it moves back
and forth. (See Figure 2.6.2)
The slide guide assembly can be mounted in the 19-inch rack with a depth
of mounting pitch 28 inches and 30 inches.
(2) Install right and left slide guides in the 19-inch rack. Tighten the
bracket mounting nuts after adjusting bracket location to fit it to the
depth of the mounting pitch.
(3) If necessary release the slide rail from the slide guide by pressing the
slide lock.
(4) Attach the right and left slide rails to the drive unit using the 4 screws
"A".
(5) Lift the drive unit and insert its slide rails into the guide rails
mounted in the 19-inch rack. Be sure the rails are correctly seated and
latched in the guides.
Note: The drive weighs approximately 143 lbs (65 kg), and requires at
least two people to install.
Left Slide Guide
' 1
r
m
, I
Rack Mount Striker (4)
Figure 2.6.2 Rack mount installation
B03P-4825-0002A ••• 01
2 - 9