Power Cable Connection; Interface Cabling; Figure 2.7.3 Power Cable Connector - Fujitsu M2361A Customer Engineering Manual

2.7.2 Power cable connection
(1) Loosen the 2 screws "A" holding the cable clamp. (See Figure 2.7.3)
(2) Insert the power cable into the cable clamp.
(3) Connect the 2 power lines to the AC input terminal L1 and L2 using the 2
screws "C".
(4) Connect the GND line to the drive unit FG using the screw "B".
(5)
If the AC input voltage is changed, set the connector CN69 on power supply
to the proper input voltage. (See Figure 2.7.3)
o
o
o
o
o
o
o
o
o
o
•
Figure 2.7.3 Power cable connector
2.7.3 Interface cabling
(1)
A and B cables (Data transfer interface cables)
a. Connection
Screw"C"
Screw"B"
Cable Clamp
Screw "A"
. .
Power Cable
One of the following interface cable configurations must be chosen
depending on the feature of the controller.
(Note; Dual Channel Feature is optional.)
B03P-4825-0002A ... OlA
2 - 13