Mounting Of Options; Dual Channel Option Mounting - Fujitsu M2361A Customer Engineering Manual

2.6 Mounting of Options
2.6.1 Dual channel option mounting
1 Remove the 2 screws "A" holding the interface PCB fixture.
(See Figure 2.6.1)
2 Insert the dual channel option (Dual port Interface PCB) into the right
side connector in the interface card cage.
3 Mount the interface PCB fixture by using the 2 screws "A".
4 Connect the interface cables. (Refer to Section 2.7.3)
5 If necessary, mount the line terminator. (Refer to Section 2.6.4)
Screw "A" (2)
GND Cable
Interface
PCB
fiXture
GND Terminal
Channel B
Interface PCB (BASIC)
Screw "B" (2)
Channel A Interface PCB (Dual port)
line Terminator
PCBs
Interface Card Cage
Connectors for Interface "A" cable (IN)
Connectors for Interface "A" cable (OUn
26 26
Connectors for Interface
"B"
cable
(Rear View)
Figure 2.6.1 Mounting the dual channel option
2 - 8 B03P-4825-0002A .. OlA