Mounting And Installation - SMC Networks EX510-GPR1 Series Operation Manual

Mounting and Installation

■Installation
Each SI unit is mounted and removed as shown on the following figure.
•Mounted by screw
•Mounted on DIN rail
1, Hook claw 1 over the upper side and claw 2 over the low side of DIN rail respectively.
2, Tighten the screw by Phillips screw driver until DIN rail is secured. (Tightening torque: 0.6 Nm)
3, When the DIN rail is disconnected, loosen the screw and unengaged claw 2 and then claw 1 in order.
-35-
No.EX##-OMI0032-C