SMC Networks EX510-GPR1 Series Operation Manual page 28

∗: Precautions for setting
•Set-up steps of Unit Status
(1)Turn on the Unit Status bit of hardware SW on GW unit.
(Turn on the eighth bit of SW1 is turned on)
Click "EX510 icon" on the STEP7 screen.
(2) Drag & Drop "Unit Status" in the slot.
∗: Unit Status should be inserted below than Input slot. (∗pts. Input)
∗
PLC software "STEP7" manufactured by Siemens AG is shown above. "STEP7" is a registered
trademark of Siemens AG.
①
-27-
②
No.EX##-OMI0032-C