SMC Networks EX510-GPR1 Series Operation Manual page 54

•Wiring of branch cables and e-con
•Insert the branch connector at cable side into mating connector at Input unit side.
•Connect e-con after removal of cover.
∗: For crimping of a branch connector, refer to page 17.
•Sensor connection
Utilize e-con to connect the sensor to the Input unit.
•Strip the sensor wire as shown in the right figure.
(Refer to the table below for correspondence between connector
and electrical wire gauge.)
Lead Wire Table
SMC Product No.
Color of cover
(1 pc)
ZS-28-CA-1
ZS-28-CA-2
ZS-28-CA-3
ZS-28-CA-4
ZS-28-CA-5
ZS-28-C
ZS-28-C-1
−
Transparency
∗: Note: If given tensile force more than 12N, cable may separate from connector.
•Insert the cable to the end with checking correspondence between color of cable and number stamped on
e-con. (Refer to page 42 "Internal circuit and wiring")
•It checks that the above-mentioned preparation work has been performed correctly, and "A" part shown in
the left figure is pushed by hand and makes temporary connection.
•"A" part's center is straightly pushed in by tools, such as pliers.
•e-con is cannot be reused once crimped for connection. For the connection failure such as incorrect order
of wire and incomplete insertion, please use the new e-con for sensor.
Applicable gauge
of cable ( )
Orange 0.6 to 0.9
Red 0.9 to 1.0
Yellow 1.0 to 1.15
Blue 1.15 to 1.35
Green 1.35 to 1.60
Red 0.8 to 1.0
Yellow 1.0 to 1.2
to 1.5 or less
Nominal sectional
2
area (mm )
0.1 to 0.5
(AWG26 to 20)
37104-3101-000FL (Sumitomo 3M)
0.14 to 0.3
(AWG26 to 24)
37104-3122-000FL (Sumitomo 3M)
0.08 to 0.5
(AWG28 to 20)
-53-
Product No.
3-1473562-4 (AMP)
1-1473562-4 (AMP)
1473562-4 (AMP)
2-1473562-4 (AMP)
4-1473562-4 (AMP)
∗
XN2A-1430 (OMRON)
No.EX##-OMI0032-C