SMC Networks EX510-GPR1 Series Operation Manual page 29

(3)Double-click "EX510 icon". "Properties" window is displayed.
(4)Click "Parameter Assignment" tab. In the "Device-specific parameters" folder, Change
parameter from "OFF" to "ON".
(5)Click "OK".
(6)Download the above setting to PLC.
Click "Save & Compile". After completion,
Click "Download to Module".
It is set completion in the above.
⑧
PLC software "STEP7" manufactured by Siemens AG is shown above. "STEP7" is a registered
trademark of Siemens AG.
⑨
-28-
③
④
⑤
⑦
"Unit Status"
⑥
No.EX##-OMI0032-C