(4)Double-click
"Output" part of "Order Number/Designation".
"Properties" window is displayed.
(5)Set Hold/Clear individually.
<Exp.> In case of OUT00 from Clear to Hold.
Click
"Parameter Assignment" tab. In the "Device-specific parameters" folder,
Change
"Out_00 Hold/Clear" parameter from
(6)Click
"OK".
(7)Download the above setting to PLC.
Click
"Save & Compile". After completion,
Click
"Download to Module".
It is set completion in the above.
⑪
⑥
PLC software "STEP7" manufactured by Siemens AG is shown above. "STEP7" is a registered
trademark of Siemens AG.
"Clear" to "Hold".
⑫
⑩
-30-
⑦
⑧
⑨
No.EX##-OMI0032-C