SMC Networks EX510-GPR1 Series Operation Manual page 21

•Switch setting
NOTE
1. Open the cover, and set DIP switch with a flat blade driver, etc.
2. Make sure that switch setting is performed with power supply turned off.
3. Be sure to perform this setting of the switch before use.
1. Setting of Address • UNIT STATUS • HOLD/CLR • HW/SW mode (SW1)
Setting of address is performed with SW1.
•Address setting (Switch No.1 to 7)
All setting are turned OFF at shipment and the Address is set to 0.
Make sure to set the Address within the range of 0 to 125.
ADDRESS
0
1
2
3
4
:
24
25
:
125
126
127
∗: Setting of 126 and 127 are invalid.
•UNIT STATUS setting (Switch No.8)
The setting is as follows.
Refer to page 23 for the memory map of GW status information.
At the time of shipment from the factory, the switch is set to off and the GW unit status information is not
sent to master side as an input data.
UNIT STATUS
OFF
ON
∗: If the address setting is turned on, an input setting for PLC is required.
Refer to page 24 for the details of diagnosis information.
•HOLD/CLR setting (Switch No.9)
The setting is as follows.
The setting at shipment is turned OFF, set to CLR.
HOLD/CLR
CLR
HOLD
∗: HOLD/CLR setting is made available per one point by parameter setting.
Refer to page 29 for detail.
64(No.1) 32(No.2)
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
: :
OFF OFF
OFF OFF
: :
ON ON
ON ON
ON ON
No.8
OFF The GW unit status information is not sent to master side as an input data.
ON The GW unit status information is sent to master side as an input data.
No.9
OFF Output is cleared when an communication error occurs.
ON Output is held when an communication error occurs.
16(No.3) 8(No.4)
OFF OFF
OFF OFF
OFF OFF
OFF OFF
OFF OFF
: :
ON ON
ON ON
: :
ON ON
ON ON
ON ON
Function
Function
-20-
4(No.5) 2(No.6)
OFF OFF
OFF OFF
ON
OFF
OFF ON
ON
OFF
: :
OFF OFF
OFF OFF
: :
ON OFF
ON ON
ON ON
No.EX##-OMI0032-C
1(No.7)
OFF
ON
OFF
ON
OFF
:
OFF
ON
:
ON
OFF
ON