Commissioning; Safety Precautions; Preparing The Filter Holders; Coffee Grind - Astoria SABRINA SAE DISPLAY Use And Maintenance Manual

7.

COMMISSIONING

Safety precautions

7.1
Carefully read the instructions provided in chapter 2 on page 7.

Preparing the filter holders

7.2
7.2.1 Filter holders
Place the filter-holding spring (2) in the housing of
the filter holder (1).
Take the one-cup (3) or two-cup filter (4) and press it
firmly into the filter holder.
7.2.2 Spouts
To finish preparing the filter holder, fit the one-cup
(5) or two-cup (6) spouts.
4
1
6
Properly connect the single filter with the single spout and the
double filter with the double spout.

Coffee grind

7.3
To adjust the coarseness of the ground coffee, use the
appropriate regulator located on the grinder-dispenser
hopper.
TECHNICIANS manual
7.4
7.5
3
ferent heights, the special
flippable grilles (11) that are
2
supplied with the machine can
be used.
it from the latch and rotate it
into a horizontal position.
5
needed, push it upwards, until
it latches into place.

Adjusting the external motor pump

To adjust the operating
pressure, proceed as
follows:
Press a coffee dispens-
ing switch;
Adjust the pressure
by turning the screw
located on the pump
(1) so as to obtain a
value between 8 and
9 bar: tightening the screw increases
the pressure, and loosening it reduces
the pressure. Check the pressure via the
pressure gauge (2) located on the front
of the machine, or via the display (3) if
there is one;
Switch off the dispensing switch.

Raised cup grilles

When using cups with dif-
To use the grille, unhook
When it is no longer
Sabrina
1
2
3
11
29 72
of