Storing The Manual; Method For Updating The Instruction Manual; Recipients; Glossary And Pictograms - Astoria SABRINA SAE DISPLAY Use And Maintenance Manual

Storing the Manual

1.2
The Instruction Manual must be stored carefully. The
manual should be stored, handled with care with clean
hands and not placed on dirty surfaces. The Manual must
be stored in an environment protected from moisture
and heat.
Do not remove, tear or arbitrarily modify any of its
parts.
On the Qualified Technician's request, the manufac-
turer can provide additional copies of the machine's
Instruction Manual.
Method for updating the Instruction
1.3
Manual
The Manufacturer reserves the right to modify and
make improvements to the machine without providing
notice or updating the Manual that has already been
received.
Moreover, when substantial changes have been made
to the already installed machine involving the modifica-
tion of one or more chapters of the Instruction Manual,
the manufacturer will send the Qualified Technicians
the chapters affected by the changes or a revision of
the entire Manual.
It is the Qualified Technicians' responsibility, to re-
place the old document with the new revision.
The Manufacturer is responsible for the Italian con-
tent. Translations cannot be fully verified; therefore, in
the event of inconsistency, users can refer to the Italian
version or if necessary, contact the Manufacturer who
will make the appropriate changes.
If the Manual should become illegible or otherwise hard to consult,
Qualified Technicians are obliged to request a new copy from the
Manufacturer before carrying out any work on the machine.
IT is absolutely forbidden to remove or rewrite parts of the Manual.
The instructions, drawings and documentation contained in this
manual are confidential and the sole property of the Manufacturer.
They may not be reproduced in any way, either in full, or in part
without prior authorisation.
The Qualified Technicians are responsible for complying with the
instructions contained in this Manual.
Should any incident occur as a result of incorrect use of these
recommendations, the Manufacturer declines any liability.
TECHNICIANS manual

Recipients

1.4
This Manual is intended for the Manufacturer's Qual-
ified Technicians, to whom the following operations
pertaining to the machine are assigned:
Transport and handling;
Storage;
Installation;
Commissioning;
Maintenance;
Cleaning;
Spare part replacement;
Emergency operations and faults;
Decommissioning;
Disassembly;
Disposal.
RECIPIENT QUALIFICATIONS
The machine is intended for a professional non-gen-
eralised use, therefore the Qualified Technicians must:
Have attended the training courses organised by the
Manufacturer relating to the type of machine;
Be aged 18 and over;
Be physically and mentally fit to use the machine;
Be able to understand and interpret the Instruction
Manual and the safety requirements;
Know the safety procedures and how they are im-
plemented;
Be able to use the machine;
Have understood the procedures of use as defined
by the machine's manufacturer.

Glossary and Pictograms

1.5
This paragraph lists uncommon terms or terms whose
meanings are different from those most commonly used.
Abbreviations are explained below, as well as the
meaning of pictograms describing the operator's
qualification and the machine status; they are used to
quickly and uniquely provide the information needed
to correctly and safely use the machine.
Sabrina
5 72
of