Astoria SABRINA SAE DISPLAY Use And Maintenance Manual page 43

8.2.10 Update Logo
With this command, you can custom-
ise your logo and the display screensaver.
Once the button has been pressed, the
software will load the new pre-prepared
Update Logo
logo, which is located on the USB stick.
The instructions for preparing the logo and screen-
saver are indicated below.
PREPARING THE LOGO
To install the new logo on the machine's display, the
"custom.bin" file must be replaced with the new one
containing the custom graphics. This file is located in the
CUSTOM folder on the supplied USB stick.
To generate this file, use the special tool which is sup-
plied and can be installed on any Windows-compatible
computer.
HOW TO PROCEED:
If you have not already done so, install the "Custom-
Builder-Setup-v1-0-0-0.exe" build tool onto a PC;
Once installed, launch the "CustomBuilder" software;
the screen below will open:
Click on the "browse"
screen to load the new logo, then click "browse" again
under the right screen to load the screensaver;
TECHNICIANS manual
button under the left
When both graphics have been loaded, the button
to export to file will appear
and save the "custom.bin" file in the CUSTOM folder
on the USB stick.
Then insert the USB stick into the machine and update
the logo.
Once uploaded, the images will be resized. You should not use
images that are too big;
Do not use the provided USB stick to download updates, always
use a new USB stick.
The logo can only be customised on machines with a serial
number of 664817 onwards.
Sabrina
. Click on the button
43 72
of