Commissioning; Safety Precautions; Grinding And Dosing; Preparing The Filter Holders - Astoria CORE 200 SAE 2 Gr Use And Maintenance Manual

Core200
6.

COMMISSIONING

Safety precautions

6.1
Carefully read the instructions provided in chapter I.

Grinding and dosing

6.2
It is important to have a dosing-grinding device next
to the machine with which to grind the coffee to use
daily.
The grinding and the dosing of the coffee must be
done according to that indicated by the manufacturer
of the dosing-grinding device. The following points are
also to be kept in mind:
• to obtain a good espresso it is recommended not to
keep large stocks of coffee grains. Observe the expiry
date indicated by the producer.
• never grind large volumes of coffee, it is advisable
would be to have the quantity contained in the dos-
ing device and use it if possible by the end of the day.
• if possible, never buy
coffee that is already
ground as it expires
quickly. if necessary, to
buy it in small vacuum-
sealed packages.

Preparing the filter holders

6.3
6.3.1 Filter holders
• Place the filter-holding spring (A) in the housing of
the filter holder (B).
• Take the one-cup (C) or two-cup filter (D) and press
it firmly into the filter holde.
6.3.2 Spouts
To finish preparing the filter holder, fit the one-cup
(E) or two-cup (F) spouts.
C
B
A
F
E
26 54
of
roperly connect the single filter with the single spout and the
double filter with the double spout.
6.3.3 Preparing the filter holder
• Fill the filter with a dose of ground coffee (circa 6-7
gr.) and press it with the press;
• hook the filter-holder to the unit without closing it too
tightly in order to avoid excessive wear of the gasket;
• for the same reason it is recommended to clean the
edge of the filter before attaching the filter holder to
the dispensing unit;
follow the procedures specified by the manufacturer
of the grinder.

Raised cup grilles

6.4
When using cups with different heights, the special
flippable grilles that are supplied with the machine can
be used.
To use the grille, unhook it from the latch and rotate
it downwards into a horizontal position.
When it is no longer needed, push it upwards, until it
latches into place.

Dispensing compartment lighting

6.5
D
To turn the machine's compartment light
on and off, press the switch (3).
3
TECHNICIANS' manual