Front And Rear Panels; Antenna - DFI EC700-AL User Manual

Assembly
X

Front and Rear Panels

The front and rear panels are secured onto the system board via the
I/O stand-offs and screws as shown below.
VGA COM 3
Front Panel
DV-In
Rear Panel
Note:
It is highly unecessary at any point of the installation process that the I/O stand-
offs and screws be removed from the front and rear panels.
User's Manual | EC700-AL
COM 4
180°
COM2 COM1
Assembly
X

Antenna

There are antenna holes reserved on the front panel and by default covered by rubber plugs.
Please remove the plug prior to installing an antenna.
Antenna
Hole
Before installing the antenna, please make sure that the following safety cautions are well-
attended.
1. Make sure the PC and all other peripheral devices connected to it has been powered
down.
2. Disconnect all power cords and cables.
Connect the internal cable to the board's antenna connector, screw the antenna connector
through the antenna hole on the front panel with washers and nuts, and screw on the antenna
as illustrated below.
Board Connector Cable Antenna Connector
Chapter 2
HARDWARE INSTALLATION
Antenna Antenna
Hole Hole
Washer Nut Antenna
Chassis Wall
12