Front And Rear Panels - DFI VC230-AL User Manual

Assembly
X
To install the top cover, we suggest that the top cover be placed on a worksufrace with the
inside facing upward. The location of the stand-offs and the top cover screw holes are as illus-
trated below. Orient the assembly of system board and panels so that ...
e l
a n
t P
o n
F r
User's Manual | VC230-AL
1. the CPU on the system board sits right
on top of the interface metal on the
inside of the top cover;
2. the brass stand-offs on the system
board align with the screw holes on
the top cover;
3. the front and rear panels sink into the
indentations along the long edges of
the top cover.
B
A
e l
a n
t P
o n
F r
A
A
A

Front and Rear Panels

The front and rear panels are secured onto the system board via the
I/O stand-offs and screws as shown below.
Front Panel
Rear Panel
Chapter 2
HARDWARE INSTALLATION
After the top cover is correctly attached to
the system board and panels, screw on the
four F3*5 zinc-coated screws (A) at four
corners, and a M3*6 spring screw (B) for
making sure the CPU contacts the inter-
face metal.
x4 x1
11